Thread: 1605 ballnuts
Threaded View
-
30-03-2013 #6
Last Activity: 08-09-2018
Dudz
Looking at your drawing the out most holes for the nut show 38mm, but the mounting holes show 60mm between cntres. the drawing looks like they should be roughly in line. Can you just check those measurements please. I will be near Richelieu in a few weeks and will be driving down through LeMans but not as soon as you would like.
It might be worth you popping along to here Accueil - Aéro Modèle Club Armoricain on the 14th April. You could make some good friends local that may be able to help you out. I remember a chap from Loudeac was visiting near by and cam to my local flying club years ago.If the nagging gets really bad......Get a bigger shed:naughty:
-
The Following User Says Thank You to Swarfing For This Useful Post:
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
1605/1610 have they sent the wrong ones?
By kingcreaky in forum Lead Screws, Nuts & SupportsReplies: 4Last Post: 30-07-2013, 09:22 PM -
Securing and Aligning Ballnuts
By WandrinAndy in forum Gantry/Router Machines & BuildingReplies: 6Last Post: 29-09-2012, 11:39 PM -
Ballnuts
By Web Goblin in forum General DiscussionReplies: 19Last Post: 04-08-2011, 11:28 AM -
What oil for ballnuts?
By Robin Hewitt in forum General DiscussionReplies: 1Last Post: 24-10-2009, 08:36 PM
Bookmarks