newbie from bristol soon to be up and running

[Swarfing]

Sure is

I must remember to shift that milling table out of the Utility room before the kids trip over it .....lol!

[martin54]

Welcome to the forum, if you still need to buy a power supply for those drivers then as Jonathan has said you would be better off with a higher voltage, think those will run up to 50v unless your buying a second power supply because the one you have won't be enough for all the motors.

Have a read through some of the build logs before you start buying new parts for the next build, it will give you a good idea of what will suit your needs best for the new machine.

Best of luck with it.