Thread: Emco Mentor Mill conversion
Hybrid View
-
02-04-2013 #1
Thanks Swarfing and John. I always seem to miss the easy solutions, although I was hoping to make all mods reversible. Didnt want to hack up something that I might be able to sell. Are 415v motors for these machines worth anything?
I'll have another look and see if the end plate will come off without destroying the motor, that would be the best out come.
Thanks again
-
02-04-2013 #2
If it wires 230 - 240v delta then just wack a vfd on it and away you go :-)
If the nagging gets really bad......Get a bigger shed:naughty:
-
02-04-2013 #3
-
02-04-2013 #4
Nice to see you back Ross, was reading some of your threads the other day and said to myself "i wonder what hes upto these days".
.Me.Me
-
02-04-2013 #5
If there is no obvious opening or cap to reconfigure then maybe not? google mot or details and see what comes up.
If the nagging gets really bad......Get a bigger shed:naughty:
-
02-04-2013 #6
I think you probably can still reconfigure it , but you will need to find the star point on the windings and the rewire as delta. G.
-
02-04-2013 #7
Whether the motor can be altered to run on 240V depends on if it's wired as Star or Delta 440V.
It's a case of carefully dismantling the motor, and seeing where and how the coils are connected. If all the coil wires ultimately end up with 3 going to the power feed, and 3 joined together in at one point, it can be changed to run on 240V. However, if each of the three going in split to two, then it's already in delta and can't be changed.
-
The Following User Says Thank You to m_c For This Useful Post:
-
02-04-2013 #8
Thanks Lee, good to be back. Been converting a barn for the last 3 years and still not quite finished but need some down time to try and keep me sane.
Progress will be slow but I have a lot planned for this mill, essentially it will be full cnc but with a Arduino (or similar micro processor) to monitor speed, axis DRO and act as a standalone controller for quick manual use.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
CONVERSION: EMCO Compact 5 CNC Conversion
By sid8ball in forum Conversion Build LogsReplies: 1Last Post: 10-10-2019, 11:51 AM -
FOR SALE: Emco mill 50 cnc mill like Denford Triac
By gavztheouch in forum Items For SaleReplies: 0Last Post: 18-05-2014, 10:19 AM -
Emco conversion help needed
By Ecu-master in forum Milling Machines, Builds & ConversionsReplies: 0Last Post: 29-03-2014, 10:33 PM -
Emco mill 50 Y axis travel?
By gavztheouch in forum Emco Milling MachinesReplies: 0Last Post: 01-03-2014, 11:10 AM -
Emco Compact 5 Conversion
By Pete92 in forum Emco LathesReplies: 7Last Post: 01-10-2013, 11:31 PM
Bookmarks