Thread: mach3, steps & microstepping
Threaded View
-
08-04-2013 #5
Last Activity: 20-06-2022
Any advice on the best way to start this off now John please. I am guessing I want to set the micro stepping right down on the drivers if the gearing does the same job but is there a way to work out where to start with the steps in mach3.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Use of microstepping, external motion control boards, and related issues
By Neale in forum General ElectronicsReplies: 0Last Post: 11-06-2014, 12:17 PM -
CW5945 MicroStepping Strangeness?
By Tenson in forum Motor Drivers & ControllersReplies: 7Last Post: 10-10-2012, 04:49 PM -
eBay: 3 x PM752 Microstepping Drivers
By Iwant1 in forum Items On eBay UKReplies: 18Last Post: 24-08-2012, 11:47 PM -
Help please Steps and control?
By totts in forum Motor Drivers & ControllersReplies: 9Last Post: 31-03-2012, 07:44 PM -
The worth of microstepping?
By stuart576 in forum Stepper & Servo MotorsReplies: 4Last Post: 18-01-2012, 09:27 PM
Bookmarks