Hi all..

Been a while since I was on this forum, have now moved into a council property, with no garage..! I have tried to build a wall mounted cnc but just cant get round the noise problem... So have decided to scale down to a small desktop cnc (400mm x 400mm). I could start chopping up my rails and ballscrews, but seems the wrong way to go about this...
I will compile a list of the stuff I have in more detail but roughly it is as follows;

2 x 2mt 20mm supported rail + 4 bearing blocks
2 x 1.4mt supported rail + 4 bearing blocks
2 x 25mm ballscrews (machined to fit nema 34 mounts)
2 x 25mm ballnuts
1 x 16mm ballscrew (machined to fit nema 23 mount)
1 x 16mm ballnut
2 x nema 34 mounts
2 x nema 34 motors (4 wire 6N motors)
70v PSU and two drivers for the nema 34's..

I will get specs and serial numbers etc later today or tomorrow...
As I mentioned, I am scaling down so these will be up for sale or swap..

Any more info needed, just ask!

Steve...