VFD in main electronics cabinet/general layout?

[Ross77]

just got my VFD up and running and whilst going through the install section noticed that it can be installed in an enclosure but needed ventilation and a cooling fan. might be the same for yours! could be a bit toasty with the servo drives as well.

[m_c]

Cooling is always something to consider, however this cabinet is a bit larger than your typical homebrew CNC enclosure (I think I measured it at 1.2 x 0.8 x 0.3m), has an integral air to air heat exchanger, and previously housed a Heindenhain controller complete with all drives/transformers/contactors.