Let The Fun Begain, New build on the Table.

**Bush Flyer** · 18-05-2013

Right, I have made one small change to the Y axis to tie it all together. So no more changed till it is built. I ordered some 6082 aluminium plate and have started to construct the Z axis.
I can only do a little at a time before the pain is to severe and I have to stop, It will be a slow build but I will get there. Anyway one drawing of the change and two pictures to keep you going.

**Ross77** · 19-05-2013

looks like some good progress Mike. that back plate will help stiffen it all up.

glad all the comments didn't put you off. keep it up

**Bush Flyer** · 28-05-2013

Ok here is another part done I had to cut 3mm off the aluminium plate, as they came to large. Now the only way I could cut the 3mm off was with a hand held router and a M6 end mill with the plate held in a wooden jig. That was hard going. Anyway with stops to rest I did start to assemble the bed.