Let The Fun Begain, New build on the Table.

[JAZZCNC]

Also you may have problems with noise bundling all of your signal and power cables together.

Ian's correct here.! . . The worst thing you can do is use un-sheilded cable and tie signal and power cables together like you have here.!!

Things may appear to work ok just jogging around etc but the potential for problems increases big time while cutting with noise getting on the signal wires causing all sorts of strange things to happen.? . . . .Everything from sudden limit or E-stops trips to sending phantom signals to motors causing them to either go in wrong direction or increase steps etc.
Honestly Complete nightmare tracking down where it's coming from so anything to minimise the better and you've done everything to maximise with those cable ties and unsheilded cable on signal wires.!

Other than that looks Good and happy cutting.!