Let The Fun Begain, New build on the Table.

[Bush Flyer]

Well I now have Artcam express and Mach3 licence bought and its seems to be running well, The only concern is the stepper motors get hot after it has been running for 45 to 50 minutes is this normal the axis all run free so there is no binding in the bearings etc.

[Jonathan]

The only concern is the stepper motors get hot after it has been running for 45 to 50 minutes is this normal

Motor case temperature up to 80°C is considered acceptable.

[Bush Flyer]

That's Fine its below that I measured the two X axis motors at 71 degrees the Y axis was 68 degrees and the Z was not worth measuring, so all good will just test again after I have a long cutting job to do.
Thanks Mike.