. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 20-11-2013 #1
    Jonathan's Avatar
    Lives in Leicester (Home) or Nottingham University (2nd Home), United Kingdom.
    Jonathan
    Last Activity: 05-04-2020 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 3,571. Received thanks 325 times, giving thanks to others 8 times. Referred 1 members to the community.
    Quote Originally Posted by Bush Flyer View Post
    The only concern is the stepper motors get hot after it has been running for 45 to 50 minutes is this normal
    Motor case temperature up to 80°C is considered acceptable.
    Old router build log here. New router build log here. Lathe build log here.
    Electric motorbike project here.
    Reply With Quote Reply With Quote
  2. 20-11-2013 #2
    Bush Flyer's Avatar
    Lives in Elgin, United Kingdom.
    Bush Flyer
    Last Activity: 18-07-2015 Has been a member for 9-10 years. Has a total post count of 72. Received thanks 2 times, giving thanks to others 9 times.
    That's Fine its below that I measured the two X axis motors at 71 degrees the Y axis was 68 degrees and the Z was not worth measuring, so all good will just test again after I have a long cutting job to do.
    Thanks Mike.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 27 users browsing this thread. (0 members and 27 guests)

Similar Threads

  1. Plasma table build, first question....
    By Davek0974 in forum Plasma Table Machines
    Replies: 51
    Last Post: 01-08-2014, 03:11 PM
  2. BUILD LOG: 4' x 4' plasma table build in Canada
    By 190-v8 in forum DIY Plasma Build Logs
    Replies: 2
    Last Post: 02-02-2014, 01:19 AM
  3. 4' x 4' plasma table build in Canada
    By 190-v8 in forum Plasma Table Machines
    Replies: 0
    Last Post: 29-01-2014, 12:27 AM
  4. MY 4`x 4` table
    By Steve-m in forum DIY Plasma Build Logs
    Replies: 65
    Last Post: 30-10-2012, 12:07 AM
  5. 3M x 2M Plasma table build
    By MonoNeuron in forum DIY Plasma Build Logs
    Replies: 14
    Last Post: 01-09-2009, 11:11 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules