Mach3 table display

[martin54]

Road runner was tiny because it's coded for imperial units.

The table extents show has a fine grey Dotted outline on my system not a red box.

ok that's not something I thought about Dean, just used the road runner as it was what they used on the tutorial video. Same with the table display, I said I didn't have a red box because that is what it showed on the tutorial video, I am guessing they have changed that with one of the revisions then but I don't have anything showing for the table at all.
Will be up at the unit tomorrow so will check everything again, was just hoping to have something else to try before I went up there, not having an internet connection in the unit doesn't help either.

[martin54]

OK so I never got to the bottom of this, couldn't see anything I had done wrong so uninstaled mach & all it's folders & drivers & then re installed it. Set everything up again & I am pretty sure all the settings were exactly the same as before.
I now have a grey dotted line showing when in table display so looks like it is working ok now.

[John S]

Try double clicking the display screen to make it update.

[martin54]

seems to be working now I have re installed mach3 thanks John.