From Chinese to Taffynese

[Carlb1058]

It's actually quite a clean space in there, ideally suited for this

Miles of space for sure - all that really needs to come out of it frame wise is the CD/DVD/Zip support that runs the full depth of the case, only pop rivetted in so that was easy.

My problem now is the actual wiring, I'm a tad confused - I can see where X, Y, Z, the E-Stop, switches, mains power goes etc but the original PSU is not connected apart from a 24v plug and one that says PWM to the yoocnc board. I'm guessing I'll need the one board (the lower one) but I'd really like a knowledgeable comment here as I'm not in the mood to blow the new stuff up.

The attached image shows the following things as marked OK - I've sussed them out, what's confused me is there are two power connections, 18v and 36v plus the 24v going from the one board to the other.

If I do need to use the lower board, do I make the 24v power cable a three way split for each stepper?



Pity they had to make the X,Y,Z wires all yellow and white - cheap swines!!!