. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 28-04-2013 #16
    HankMcSpank's Avatar
    Lives in London, United Kingdom.
    HankMcSpank
    Last Activity: 10-06-2024 Has been a member for 9-10 years. Has a total post count of 623. Received thanks 10 times, giving thanks to others 59 times.
    I am wondering here if my lowly cnc machine could be pressed into service to get a reasonable finish on on the top visible edge ....drop a part into a pre cut slot on a holding jig....tighten a couple of holding screws, then run a dremel (fitted with a grinding wheel) along the top edge to a very fine depth? (the depth being so minute, that I doubt my machine would get stressed?)
    Last edited by HankMcSpank; 28-04-2013 at 10:38 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Milling mild steel
    By dudz in forum Machine Discussion
    Replies: 33
    Last Post: 16-02-2014, 02:31 PM
  2. RFQ: Several mild steel parts
    By dudz in forum Projects, Jobs & Requests
    Replies: 6
    Last Post: 26-08-2013, 11:37 AM
  3. Cutting 1.6mm mild steel with a CNC machine?
    By HankMcSpank in forum Machine Discussion
    Replies: 4
    Last Post: 01-05-2012, 09:56 PM
  4. Homemade desktop CNC - cutting 0.8mm mild steel out the question?
    By HankMcSpank in forum General Discussion
    Replies: 7
    Last Post: 16-04-2010, 09:37 AM
  5. Where to get 1/8" sheet mild steel laser/water jet cut?
    By HankMcSpank in forum Marketplace Discussion
    Replies: 28
    Last Post: 10-02-2010, 01:28 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules