-
29-04-2013 #1
I am a newbie and have looked without success for a answer to my problem.
I have a JHF 2030 router with a RZNC hand controller. At the price asked I could not pass and I have the room (it will cut a 3 x 2 metre sheet!)
When set to distance via the hand controller the steppers move about twice the setting. The default pulse rate on the RZNC is 400 and changing that to 155.5 gives a accurate movement but I am not sure about the sound of the motors. They do not falter or judder but do sound a bit different than before.
The stepper contollers are all set to a step rate of 4000. The lowest step rate via the dip switches is 400.
My questions are:
Is it better to change the stepper controller step rate or the pulse rate via the hand controller firmware?
If I did experiment with the dip switch setting will I bugger something?
The stepper motors have no id at all. They have a 12.7mm dia shaft with a keyway. They are 8 wire and I don't know enough to say how they are wired and JHF have not given me a answer.
regards
Jopo
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
How-To: Feed Rate Calculation
By Lee Roberts in forum Machine DiscussionReplies: 20Last Post: 25-03-2020, 04:09 PM -
My turn for help with Pulse multiplier for test rig.
By JAZZCNC in forum Electronic Project BuildingReplies: 75Last Post: 20-06-2014, 06:09 PM -
stepper acceleration rate - limits?
By dsc in forum Stepper & Servo MotorsReplies: 11Last Post: 02-03-2014, 02:25 PM -
MPG or Hand Wheel Pulse Encoder where to buy in UK?
By suesi34e in forum Marketplace DiscussionReplies: 5Last Post: 02-01-2014, 04:41 PM -
Help withController dip switch settings and Mach3 motor tuning
By liamo1991 in forum Motor Drivers & ControllersReplies: 2Last Post: 15-11-2013, 02:22 AM
Bookmarks