Toolpath not cutting as shown

[Bazzer]

Hi, if you went down the Eagle route, are you sure you got mach3 and not ncstudio version.
I have attached a circle profile 200x200mm 0.5doc in .nc format to try just in case.

Profile 1NCStudio.nc

[Phizell]

Hi Bazzar,

Yes did go down the eagle route and the machine seems of a good quality (not that I know cnc machines, but I do know tools and engineering).

I have tried 8 different files produced by me and also sent to me from the supplier and even though he says they work on his machines with the same XML file, I cannot get it to work.

I will try it tomorrow but I have a feeling it will be no good, the biggest problem is not knowing if its software or hardware and having changed all the hardware apart from the supplied CNC and the controller I really can only think its the hardware (control board) if I take it as read that the XML file works on other machines that are the same with the supplier.

Once again, thank you I really do appreciate all the help you, this forum and users give.