Hi Jonathan,

Firstly thank you for trying to help!

I have tried to upload the xml file but the forum wont let me so if its ok with you I will try and send it via private message.

Could you tell me how to identify the break out board?

The toolpath is of a square and a circle in the middle it then tries to cut part of the square and part of the circle then nudges up a small way and starts again.

I am at the point of sending this machine back, because so far this is not out of the box usable and I have not had the best of help from the supplier who I am sure believes its me.

Could it be me? Could it be both of my computers both the new parallel leads and the new PCI Board, should I have to do more than get it out of the box, plug it in and learn how to use the software......as I have never bought a CNC I dont know if my expectations are right? I have got to say I have never had problems like this before even when I used to test sign software for signlab.

Any help, is help and if you think I should send this back please don't hesitate to tell me