Thread: Question on PCB and routing
Threaded View
-
11-05-2013 #13
Thanks MC very much appreciated, I’d like to think of this project as evolving so adding things to make it better is exactly right
I have some 220 uF 25v Low ESR 8mm dia x 15 mm high 3.5 mm LS ( UPW1E221MPD) from a project also some Panasonic small-form but not sure what statsLast edited by Fivetide; 11-05-2013 at 10:28 PM.
Fiction is far more plausible when wrapped around a thread of truth
Nothing great was ever achieved without enthusiasm.
Ralph Waldo Emerson
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
routing aluminium help :)
By don_jarr in forum Metalwork DiscussionReplies: 18Last Post: 27-11-2012, 09:05 PM -
PCB Isolation Routing
By Mad Professor in forum General DiscussionReplies: 3Last Post: 16-03-2011, 09:46 PM -
PCB Isolation Routing
By CHudson in forum Milling Machines, Builds & ConversionsReplies: 5Last Post: 10-10-2010, 08:34 PM -
BUILD LOG: routing 3d?
By proddy in forum DIY Router Build LogsReplies: 2Last Post: 03-08-2009, 11:20 PM
Bookmarks