Thread: Motor Identification
Hybrid View
-
14-05-2013 #1
Last Activity: 23-01-2017
OMG I searched for hours before i came and posted that, Thanks very Much...
Originally Posted by Swarfing
So next question will be....Spindle???? with pulleys???? Yes---No??
Rick
Hey GEOFFREY.. yes what a gift, but then they dont come without cultivation and a few sacrifices on my part i can tell you LOL...Always bear in mind that your own resolution to succeed is more important than any other - Abe Lincoln
-
14-05-2013 #2
Last Activity: 08-09-2018
No worries Rick, big question is though what are your plans for it? what sort of size is it?
If the nagging gets really bad......Get a bigger shed:naughty:
-
14-05-2013 #3
Last Activity: 23-01-2017
Well the shaft is a little under an inch by the looks of things although ive not uncrated it to have an accurate measure i reckon the motor is over 10 inches long....if i can i would like to use it as a motor to drive a spindle, not even sure that is possible... but here is hoping LOL Originally Posted by Swarfing
RickAlways bear in mind that your own resolution to succeed is more important than any other - Abe Lincoln
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
AC servo motor to replace a 3 phase induction motor on a mill spindle.
By rnr107 in forum Spindles & Drive MotorsReplies: 2Last Post: 23-04-2014, 03:14 PM -
Motor identification help
By Clive S in forum Stepper & Servo MotorsReplies: 3Last Post: 25-09-2013, 06:35 PM -
PARAJUST VFD part identification
By asto in forum Motor Drivers & ControllersReplies: 0Last Post: 28-04-2013, 10:08 PM -
Machine Identification - What Is This?
By machineage in forum Milling Machines, Builds & ConversionsReplies: 9Last Post: 18-02-2013, 01:36 AM -
servo motor as spindle motor
By Scott in forum General DiscussionReplies: 1Last Post: 03-10-2010, 06:42 PM
Bookmarks