Thread: Motor Identification
-
14-05-2013 #1
Hi All, Ive just been gifted a Sepro MPA-II V2 Robot,mine is the Electric Version as opposed to the Air/Pneumatic.
This is the Link to the Site:-
Sepro Sprue Pickers & Pick and Place Robots for Injection Moulding Machines - Tepro
I dont have the pendant, my control panel is the Lower one.
Its in bits but was working when crated, my question is, does anybody know how i can find the maximum speed of the monster servo motor that comes with it.. all the information i have is as follows.
Infranor Drive With
Brushless Servo Motor
24V-12Nm
22A
VR-24V
Model: LD640EGA2300
There are a few other numbers but i cant make any sence of them
RickAlways bear in mind that your own resolution to succeed is more important than any other - Abe Lincoln
-
14-05-2013 #2
Don't know anything about robots, but WOW what a gift!! Good luck with it Rick. G.
-
14-05-2013 #3
Here you go
www.parvex.com/fichesmot/english/ld/ld640eg.pdfIf the nagging gets really bad......Get a bigger shed:naughty:
-
14-05-2013 #4
OMG I searched for hours before i came and posted that, Thanks very Much...
So next question will be....Spindle???? with pulleys???? Yes---No??
Rick
Hey GEOFFREY.. yes what a gift, but then they dont come without cultivation and a few sacrifices on my part i can tell you LOL...Always bear in mind that your own resolution to succeed is more important than any other - Abe Lincoln
-
14-05-2013 #5
No worries Rick, big question is though what are your plans for it? what sort of size is it?
If the nagging gets really bad......Get a bigger shed:naughty:
-
14-05-2013 #6
Well the shaft is a little under an inch by the looks of things although ive not uncrated it to have an accurate measure i reckon the motor is over 10 inches long....if i can i would like to use it as a motor to drive a spindle, not even sure that is possible... but here is hoping LOL
RickAlways bear in mind that your own resolution to succeed is more important than any other - Abe Lincoln
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
AC servo motor to replace a 3 phase induction motor on a mill spindle.
By rnr107 in forum Spindles & Drive MotorsReplies: 2Last Post: 23-04-2014, 03:14 PM -
Motor identification help
By Clive S in forum Stepper & Servo MotorsReplies: 3Last Post: 25-09-2013, 06:35 PM -
PARAJUST VFD part identification
By asto in forum Motor Drivers & ControllersReplies: 0Last Post: 28-04-2013, 10:08 PM -
Machine Identification - What Is This?
By machineage in forum Milling Machines, Builds & ConversionsReplies: 9Last Post: 18-02-2013, 01:36 AM -
servo motor as spindle motor
By Scott in forum General DiscussionReplies: 1Last Post: 03-10-2010, 06:42 PM
Bookmarks