Ballscrew or leave alone?

**John S** · 19-05-2013

Done a few WM16's and one thing to bear in mind is that some convert easily and some don't.
The stumbling block is the bed in the middle, the casting when being cast, sags and make the gap tighter in the middle.
No problem with the top, that's machined so no sag. From the ones I have done it's 50/50 if a ballnut clears.

So worst scenerio is to get someone with a big mill to take a lick out or angle grind a clearance grrove.

WM14 are usually OK, I haven't come across a bad one but WM 18's 'always' need machining

**manofgresley** · 20-05-2013

Many Thanks, Any thoughts on the couplings?

Ray

**John S** · 20-05-2013

Oldhams, they are the only non backlash coupling that works CORRECTLY in two planes.
All the others are fück ups.

**manofgresley** · 24-05-2013

Hi John

I agree, i have used Oldham couplings for many years, i just thought things may have moved on a little, they seem so expensive these days.

Regards
Ray

**John S** · 24-05-2013

Unless I'm out of touch with other couplings, not that I'd use them, I thought they were about the same price.
I get mine from ARC, used to buy off RS but they have cut their range right down.

**JoeHarris** · 24-05-2013

Not sure if you have looked at buying your ballscrews from China? There is a massive cost difference between China and the UK. Check out Linearmotionbearings2008 on ebay.