Dust and Chip extraction for large matrix table machining centre.

[gavztheouch]

I am setting up a large matrix table Thermwood c53 router, one if the last jobs I have to do before flycutting the bed is to setup a suitable extraction system for the machine. Is there anyone here who is running a similer sized machine (5" by 10") that could advise on the best type of extraction unit for the job. I have a single bag 1hp workshop extraction unit, but I doubt it will have the ooomph and capactity to clear dust.

Cheer
Gav

[GEOFFREY]

For inches read feet!!! G. Sorry Gav. G.

[gavztheouch]

Woops, yes that should read 5' by 10'. Better stick to metric :)