Pilz Relay info

[JAZZCNC]

Hi Ray,

That would be me.! You didn't actually purchase from me, I purchased it for you from Ebay if I remember correct.?
I tested it before sending to you so know it works so suspect you have something wired wrong.?
The first place to check would be that there's a Jumper wire between X1-X2 if this is not present then it won't energise. (Think I left one connected actually.?)

Next check the switches and/or E-stop connections between T12/T22 and T11 are NC (normally closed) type and working correct.
Both T12 and T22 need to connect to T11 for the Relay to Work.

Now when the Momentary Reset button connected between T33 & T34 is pressed the Relays should energise switching the contacts and the Channels light up.

Best way to test the relay is to disconnect from switches etc and put jumper wires between X1-X2 and Between T12-T22 to T11. Then when T33 & T34(reset) are shorted the relay will energise and stay energised until any of the above connections are broke.
This is how I tested the Relay before sending to you.

If you tried to contact me and I haven't replied then very sorry but unfortunately serious family health issues have kept me off the forum with little time for anything else, even answering emails with lots getting missed or put to the wayside for later but unfortunately getting forgotten about.!!

[manofgresley]

Many Thanks

I was having a senior moment, i new i had asked that question before, but i could not remeber well.

Ray