Denford ORAC lathe spindle nose upgrade

[Chaz]

Hi Chaz,
No idea what the maximum is... I never reached it.... But I did turn 2" bars without any problem.
In brass I'd say as long the stock clears the bed and the carriage you should be fine (using the internal jaws).

What kind of diameter are you thinking of ?

The spindle bore is 20mm this limit the diameter if you have a long bar that need to go throu the spindle.
But apart from that, the Orac is a very capable lathe. I mostly use it on stainless and a bit of ali. Brass would be a piece of cake.

RNR

For brass, around 60mm. For Alu - 140mm (which I think will be too big).