Hand Ergometer

[Clive S]

Irving Can't seem to open that link. ....Clive

[irving2008]

Strength calcs: Calculate for input gear as worst case (Ref: Spur Gears)

Input torque = power/revs = 90/6 = 15Nm, add 50% for safety = 22.5Nm
Tangential force on tooth Ft = 2 * torque/PCD = 2 * 22.5/.01875 = 2400N

Bending stress = K * Ft/(b * m * Y)
K=velocity factor, estimated at 1.03
b = face width = 6mm
m = module = 1.25
Y = Lewis Form Factor = from tables, for 15T 20deg gear = .289 @ tip .49 @ centre of tooth, use .289

stress = 1.03 * 2400/( 6 * 1.25 * .289) = 1140MPa = ~165kPSI

PLA = 500kPSI so should be OK!

[irving2008]

Irving Can't seem to open that link. ....Clive

should be fixed now...