Hand Ergometer

[irving2008]

Ok, some progress. I've now got a set of gears that mesh reasonably well but I'm not happy with the print quality so I'm going to try a different slicer - the one I'm using at the moment is Sli3er and it's fast and easy to use but it doesn't seem to be the best quality. I was using Skeinforge before which is better quality output but not very friendly - I'll have another go with that over the next couple of days.

Thanks for your efforts on this. I'm in the process of drawing up slightly modified gears, the main difference being improvements to better support/locate the bearings and space the sun gear off the rotor boss - I may increase the thickness of the gears slightly. I'm also redrawing the supports, the rotor bosses and the planet carrier. I was thinking of 3D printing the carrier but I don't think the boss would be strong enough to take a grub screw to fix it to the axle (but what if the boss was thicker and had a slot for a nut to be inserted?). The other thought I had was 3D printing other components, the rotor bosses for example. I'm not sure about the cranks or the handles from a strength perspective, need to run the numbers. Also do you have any way to calculate the cost of a printed component?