. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 30-06-2013 #18
    bikepete's Avatar
    Lives in York, UK, United Kingdom.
    bikepete
    Last Activity: 24-07-2019 Has been a member for 9-10 years. Has a total post count of 91. Received thanks 3 times, giving thanks to others 2 times.
    Rotabroach annular cutter (aka mag drill cutter) often does a good job on sheet too... but you'd probably need a mill to hold the shank (fits nicely in a 19 mm ER32 collet). Sizes go down to 12 mm in standard series, never tried the 'mini' ones.
    --
    ah just seen it's a 1/4 inch hole so as you were...
    Last edited by bikepete; 30-06-2013 at 10:10 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. The new probe and finding the center of a hole
    By Ricardoco in forum Probing, Digitizing & Scaning
    Replies: 9
    Last Post: 13-11-2015, 06:43 AM
  2. Hole Radius
    By benkat in forum Machine Discussion
    Replies: 0
    Last Post: 03-03-2014, 05:29 PM
  3. SBR16UU Centre hole.
    By cambesol in forum Rails, Guideways & Bearings
    Replies: 3
    Last Post: 25-11-2013, 05:39 PM
  4. 6mm shaft to 6.35mm hole?
    By JuKu in forum Metalwork Discussion
    Replies: 3
    Last Post: 15-12-2012, 02:29 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules