Thread: G codes
Threaded View
-
30-06-2013 #1
Hi All,
Just had a sudden thought (most painful) about G codes and the movement they perform.
If you issue a G01 x5 Y10 from x=0 and y=0 does the controller move the x axis half the speed of the y axis, as I think it should or am I being dumb!!
peterLast edited by ptjw7uk; 30-06-2013 at 05:32 PM. Reason: miising word
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Difference between Mazatrol and G-codes
By hoezap in forum Mazak, Yamazaki MachinesReplies: 5Last Post: 23-04-2023, 04:59 PM -
Stepper Motor Wire Colour Codes
By c cunningham in forum Stepper & Servo MotorsReplies: 14Last Post: 26-01-2011, 02:13 PM
Bookmarks