1rst build, time to do next step

[Gytis]

Hello,

quick update., the Version_2 is nearly done.
now I thinking about X axis ball screw fitting,
my very first idea was to put it between the aluminum profiles, but now I'm not sure or it good idea, I think distance is to big between rails and screw approx.150mm?
what if I run it through the side plate support box?, right now there is few brackets., just one what I do not like, that the screw will be very few cm. above the table.
But maybe I can fix on each side of the box some brush or seal to wipe the dust away from screw ?

btw, what about design? Version_2 will be stronger then the first?

Thanks