Printed or milled request - Sorted

[Clive S]

I have printed these off as to see what they are like but do you need those bits that stick out on the side of the pushers 3D printing is not good with overhangs so they have to be printed vertical. I think the model could be improved for 3D printing.

If you pm me with an address I will send you them foc. Clive

[Dwayne Dibbley]

If you are regarding the black bits on the above picture then no, they are the micro switches?

Thanks everybody for the help

[Clive S]

I was referring to the lugs on the side of the green bits. If they were not on i.e. square it could be printed flat and it would be a better print.

[Dwayne Dibbley]

I was referring to the lugs on the side of the green bits. If they were not on i.e. square it could be printed flat and it would be a better print.

yes they are needed :( but could be tapered i guess - see this image showing them in place: