-
30-07-2013 #1
through fear of putting people off using him, im not going to say where I got these from
neither, am I going to suggest its a mistake on his behalf (even though ive checked my order)
see attached photo
the screw on the right, is meant to be my Z screw & 1605 and the one on the left is meant to be my Y screw & 1610
correct me if im wrong, but arent both 5mm pitch?
Last edited by kingcreaky; 30-07-2013 at 07:16 PM.
-
30-07-2013 #2
It's probably a two start screw - I remember Chai sold Jazz some twin start 10mm pitch screws, but fortunately he noticed before sending them back! Just spin the nut one revolution and see how far it goes, or look at the thread at one end and see if you can see one or two 'ends' to the thread.
-
30-07-2013 #3
-
30-07-2013 #4
as always jonathon, you are right... (you will never be married)
-
30-07-2013 #5
I had the same panic after I spent hours unwrapping the things. Think mine have them marked on the ball nuts as to what they are.
Dan
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
What has gone wrong????
By Davek0974 in forum Plasma Table MachinesReplies: 54Last Post: 05-09-2014, 12:25 AM -
1605 ballnuts
By dudz in forum Lead Screws, Nuts & SupportsReplies: 6Last Post: 30-03-2013, 09:31 AM -
FOR SALE: THK 1605 Balll screw and Nut
By michael in forum Items For SaleReplies: 1Last Post: 28-07-2011, 08:34 PM -
Stiff 1610 ballscrews, need help.... asap.
By ccmarco in forum Lead Screws, Nuts & SupportsReplies: 10Last Post: 05-12-2010, 10:01 AM
Bookmarks