Steel frame cnc router design/build

[JAZZCNC]

I am going to be running the X-axis with 2 screws & one motor....also the motors I have at the moment are 1.8Nm. Not ideal I know - but its what I have to start with.

Oh dear your stuffed.!!!. . . Lol

Well in this case then your really bating uphill and may struggle bad With those small motors.? . . . So with only 24V then I'd suggest running 3:1 to increase torque and suffer the speed loss.
When you have larger every thing then drop back to 1:1. . !!

Make sure the motors are wired in parallel not series has well else your double stuffed when speed rises. . .Lol

What drives are you using.?

[CraftyGeek]

I bought the drivers years ago when there wasn't anywhere as much choice at the cheaper end of the market:
Single Driver

Also have the LPT quick connector from there as well.

I plan on replacing it all when the machine is running....but that will be a way off.

[JAZZCNC]

I bought the drivers years ago when there wasn't anywhere as much choice at the cheaper end of the market:
Single Driver

Ah ah . . . Mr Rout-out CNC Well I better keep quite then or I'll get banned again. . . Lol

I plan on replacing it all when the machine is running....but that will be a way off.

Ermm. . .Well all I'll say is try to Make it sooner rather than later.!!