JBEC CNC Router System is now available in the UK

[StoneyCNC]

looking forward to seeing those stoney ,my first thoughts were theres skate type bearings hidden away in there.nice machines.

haha - fair, the saying goes - its whats "not said" that can leave questions... gutted pictures of her with he clothes off and more explanations to come ASAP.

I see what your saying and while this may be fine for lighter work like cutting woods etc, which I'm getting the impression most of these machines have been marketed and sold to do I can tell you for sure that it will be a very different case if it starts cutting Aluminium at any usable depth.
I've made several steel framed machines which easily match and surpass the strength of your machine and I can tell you 100% that when rough cutting Ali at 3-4mm+ DOC with larger cutters (upto 12mm) it will transfer thru the frame.
This is where my experience with cutting mostly aluminium comes in and the electronics sat directly underneath the Bed and on the frame would concern me long term.!!

Look forward to seeing under the bonnet.!

12mm cutter up to 3-4mm DOC in ALI would indeed generate significant feed forces and vibrations and of course would make everything hum Until I have hard evidence of potential to show in HD I'm going to stay in my box for now :)

You my friend are clearly NOT smelly or an illusionist and so far you have answered my questions perfectly satisfactory.!! . . Well Bit waffley but I'm ok with that. . Lol . . better to over explain than be vague thou just be careful not to over do it and start smelling like bull excrement.!!

haha - be careful - my years of University were conducive to excessive waffle - I have a better gauge on the audience here now so I shall amend tone accordingly to get rid of any smelly stuff! Smelly stuff is not the goal here! - its great to knock heads with people who know what the story is

And then there’s rednecks like me who are far too old to start learning all this shit and just want a reliable machine that works out of the box and don’t cost the same a three bedroom semi. So I rely on people like Jazz to cut through the bull, bring the Spanish inquisition down upon potential sellers so I’m not spending hours crying into my milk about cowboys like StrikeCNC. And thus if you are able to pass his integrity check without any long term metal issues you will defiantly be on my list of potential new machines (if and when ) my new project makes any money.

haha great response :) Its great to get an integrity check by someone with such experience...! And a machine should work to claimed spec - end of.