Resistor Calculator

[Lee Roberts]

As it says on the "Tin":

[ZeroCount]

As it says on the "Tin":

Just be careful, that equation assumes the LED requires 20 milli Amps of current, the proper equation is (Vsupply - Vled) = IR, or R = (Vsupply - Vled) / I in this case. V is in Volts, I is in Amps, and R in Ohms.

20 mA = 0.020 Amps.

Some minature LEDs go pop on less than 20mA :)

Technically speaking LEDs require a certain current, not a certain voltage, so it is possible to run a LED from a higher voltage supply without a current limiting resistor, as long as the supply is switched so that the average current is at or below the LEDs forward current.

[karul]

I'm using this online calculator - you will also get the power requirements for the resistor - it calculates the Wattage of the resistor - depending of the voltage of the circuit

http://led.linear1.org/1led.wiz