. .
Page 2 of 2 FirstFirst 12

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 29-09-2013 #1
    Jonathan's Avatar
    Lives in Leicester (Home) or Nottingham University (2nd Home), United Kingdom.
    Jonathan
    Last Activity: 05-04-2020 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 3,571. Received thanks 325 times, giving thanks to others 8 times. Referred 1 members to the community.
    Clive is correct, but if lower values work then your maximum step frequency can be set higher.
    Old router build log here. New router build log here. Lathe build log here.
    Electric motorbike project here.
    Reply With Quote Reply With Quote
  2. 09-06-2014 #2
    dazza's Avatar
    Lives in leicester, United Kingdom.
    dazza
    Last Activity: 19-05-2025 Has a total post count of 366.
    Thanks for posting this wal.
    I bought 6 of the same drives recently and received two of those bobs in with em.
    Almost a year on hows the bob doing?i dismissed using them after reading a bit of neg feedback but im about to try and wire up my mill so i might give them ago,
    Last edited by dazza; 09-06-2014 at 04:57 PM.
    Reply With Quote Reply With Quote
Page 2 of 2 FirstFirst 12
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. bit of advice needed for first mill
    By jmac80 in forum Milling Machines, Builds & Conversions
    Replies: 9
    Last Post: 06-04-2014, 10:59 PM
  2. Advice needed for Z Design
    By Hobgoblin in forum Linear & Rotary Motion
    Replies: 8
    Last Post: 10-09-2012, 09:18 PM
  3. Stepper Driver / PSU / Breakout board Wiring ?
    By manofgresley in forum General Electronics
    Replies: 2
    Last Post: 16-08-2012, 05:41 PM
  4. Driver wiring help...
    By mike in forum Motor Drivers & Controllers
    Replies: 12
    Last Post: 21-09-2010, 09:29 AM
  5. Driver wiring to my computer for mach3 to control
    By AdCNC in forum Motor Drivers & Controllers
    Replies: 13
    Last Post: 01-04-2010, 12:27 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules