. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 09-06-2014 #13
    dazza's Avatar
    Lives in leicester, United Kingdom.
    dazza
    Last Activity: 19-05-2025 Has a total post count of 366.
    Thanks for posting this wal.
    I bought 6 of the same drives recently and received two of those bobs in with em.
    Almost a year on hows the bob doing?i dismissed using them after reading a bit of neg feedback but im about to try and wire up my mill so i might give them ago,
    Last edited by dazza; 09-06-2014 at 04:57 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. bit of advice needed for first mill
    By jmac80 in forum Milling Machines, Builds & Conversions
    Replies: 9
    Last Post: 06-04-2014, 10:59 PM
  2. Advice needed for Z Design
    By Hobgoblin in forum Linear & Rotary Motion
    Replies: 8
    Last Post: 10-09-2012, 09:18 PM
  3. Stepper Driver / PSU / Breakout board Wiring ?
    By manofgresley in forum General Electronics
    Replies: 2
    Last Post: 16-08-2012, 05:41 PM
  4. Driver wiring help...
    By mike in forum Motor Drivers & Controllers
    Replies: 12
    Last Post: 21-09-2010, 09:29 AM
  5. Driver wiring to my computer for mach3 to control
    By AdCNC in forum Motor Drivers & Controllers
    Replies: 13
    Last Post: 01-04-2010, 12:27 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules