BOB & Stepper Drive

[GTJim]

A quick question. Can anyone clarify the wiring between the Optoport V3 breakout board and the DQ860MA stepper drive.
I ask because the breakout board has DIR, STEP, GND & ENA while the drive has ENBL-, ENBL+, DIR-, DIR+, PLS- & PLS+.
Jim

[irving2008]

Is breakout board open-collector outputs? do you have manual or online link.

General arrangement would be one of:

BOB output connects to + input of drive through suitable resistor, all - inputs connect to BOB GND (active high outputs)

or

BOB output connects to - input of drive through suitable resistor, all + inputs connect to voltage source on BOB (open collector outputs)

[GTJim]

See attached file, well if this worked.

[JAZZCNC]

Hi Jim, Just take the negs (-) to any Gnd's on the Opto V3 you won't need any Resistors the drives will work fine.

Dean.

[Clive S]

Quote I ask because the breakout board has DIR, STEP, GND & ENA while the drive has ENBL-, ENBL+, DIR-, DIR+, PLS- & PLS+.

In this case STEP = PLS if that helps further. ..Clive

[irving2008]

Hi Jim, Just take the negs (-) to any Gnd's on the Opto V3 you won't need any Resistors the drives will work fine.

Dean.

I'll bow to your better experience on this BOB Dean, the manual is useless on what type of outputs they are.

[GTJim]

Thanks for all your advise.
Many more to come. Lol
Jim

[JAZZCNC]

I'll bow to your better experience on this BOB Dean, the manual is useless on what type of outputs they are.

Sorry Irving wasn't meaning you were wrong just rushed reply and should have Said I've used several of these BOBs so know won't need Resistors on these drives. .