Threaded View
-
26-08-2013 #1
Hi All,
Title covers it all really, I have been testing my AM882 / ZPA5 setup and I have a peculiar problem that I have narrowed down but not resolved.
I can control the motor with the Pro tune software and the motor moves smoothly. However, once the settings have been written to the driver and I try to run them from the ZPA board the motor jumps, jerks and stutters. It moves, in the correct direction but just like there is interference messing up the signal.
So I have put some ferrite beads on the wires, tested it in the case and out of the case even tried another ZPA5 board from my other machine and it still behaves erratically when the BOB is in control.
I wanted to call Zapp today as I am sure I am doing something obviously wrong but its a poxy bank holiday. So as I am super impatient, I thought I would try here in the hope that someone recognises my problem.
Chris
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Leadshine website and AM882
By EddyCurrent in forum General ElectronicsReplies: 12Last Post: 24-08-2018, 01:59 AM -
I NeeD HeLp PLease AM882 a good choise
By jpsicilia in forum Motor Drivers & ControllersReplies: 34Last Post: 16-08-2014, 10:27 PM -
Well it looks like I have to bite the bullet (solid works)
By Kai in forum SolidworksReplies: 9Last Post: 03-04-2011, 01:52 AM -
How Rotary Broaching Works
By steve3d in forum Tool & Tooling TechnologyReplies: 0Last Post: 18-01-2011, 03:17 AM -
My CNC WORKS...
By emboss.shop in forum Metalwork Project ShowcaseReplies: 0Last Post: 30-09-2009, 06:04 PM
Bookmarks