meerkat

[JAZZCNC]

Hi

Ok well that's a start at least some things happening.!

Did you change the limit inputs to a different pin number.? If yes then this is the pin number your switches are connected to so just set the Home inputs to same pin number.
If not then this also explains why limits are tripping because they where sharing the same input pin number so when you press the switch Mach3 sees the input and treats it has a Limit trip not a home switch.? Mach only sees the switch has home switch when you press "Ref all home"
You will tell if sharing same input has the LED's for both will light in diagnostics.

If you don't want the limits using these switches then either change the limit pin number or disable them.

With regards to moving off the limit switches when triggered then use the limit override button on the settings screen.