Threaded View
-
06-09-2013 #7
I just noticed Jazz's point about slaved motors.
My upcoming build does not use slaved motors, but that's not to say i won't in future.
The CSMIO has an in built facility to slave motors independently of Mach. This however is NOT available in the M version.
You can however still slave motors via Mach with the CMSIO "thinking" two slaved motors are independent axes, but CSMIO-M is limited to 4 Axes so that's something anyone reading this and considering buying the CSMIO-M should be aware of.
WARNING:
Slaving within Mach could be a very bad idea when using the CSMIO-M
Please check posts below for updates, or better still check with CS-labs before making any buying decisions
Cheers
GreenyLast edited by Greeny; 06-09-2013 at 01:54 AM.
Thread Information
Users Browsing this Thread
There are currently 4 users browsing this thread. (0 members and 4 guests)
Similar Threads
-
USB TO Parallel Port DIY Interface
By Lee Roberts in forum Electronic Project BuildingReplies: 42Last Post: 17-02-2018, 07:46 PM -
What is the function of a parallel port breakout board?
By hbx in forum Machine Control SoftwareReplies: 13Last Post: 12-03-2013, 06:18 PM -
parallel port address
By Dan Brown in forum Artsoft Mach (3 & 4)Replies: 6Last Post: 07-01-2010, 12:04 PM -
Laptop, ie no parallel port?
By tompsky in forum Laptops & TabletsReplies: 3Last Post: 11-11-2008, 07:12 PM -
Which USB parallel port emulator is the best
By bruce_miranda in forum General ElectronicsReplies: 1Last Post: 18-09-2008, 03:38 PM
Bookmarks