800w spindle - noise & controlling remotely

[HankMcSpank]

I believe all are 4 bearing, forget the crap the sellers are telling.

1. check if by error you programmed 230v 60HZ instead of 50HZ

No it's programmed for 50Hz.

2. check if you properly established accelaration and deccelaration time , i use 10 seconds

I have the same setting for ACC & DEC (10 seconds)

3. check 5.4 of the manual , setting your motor
AU2 should be set to 0 instead

It was set to 0.

As far as i remember, some motors had problems with the auto tuning, so don't use it anywhere for now

uL: Base frequency 1 (rated frequency) set to 400
uLu: Base frequency voltage 1 (rated voltage) set to 230
F405: Motor rated capacity set to 0.75
F415: Motor rated current set to 3.4
F417: Motor rated speed 1410 / I am lost why i set it like this/

4. 5.9
UL=400
LL=0.0

5. 5.11
Pt=0

make sure F416 is set to 60

Mine are all set to be the same as the above.

You did not mention what the trip says exactly?

OL1

I'm seeing this info for the stored 'trip' info...

F 2.4 (The operation command value when the trip occurred is displayed)
C 132 (The inverter output current when the trip occurred is displayed. %/A - huh?)
Y 127 (The inverter input voltage (DC detection) when the tripoccurred is displayed. (%/V).
P 10 The inverter output voltage when the trip occurred is displayed. (%/V)
L 174 The inverter load factor (%) at the occurrence of a trip is displayed.
:o 2.4 (The inverter output frequency (Hz/free unit) at the occurrence of a trip is displayed.


...I'm not fully understanding the %/A or %/V ...nor the L 174 figure?