[1] Yes.

[2] Yes was all working when taken out but the guy has lost the setup XML file. to use everything, hand wheels etc will need another parallel port and the extra setting up but, and I am honest it's all down to setting up, nothing else other than lathe tools will be needed.

The breakout board was custom made for this and there is no wiring diagram other than it is wired correctly, and neatly on plugs. There is a film with it that was used to get the board etched so this can be used as a simple circuit.

[3] Christ knows, not good at this but it's an easy two man lift. The motor will take off very easy as it's on a plug so no wiring involved.

To be honest i was going to get it set up and run some custom parts on it but life has caught up with me and it means a change of plan.
I'm asking what it stands me at.