Quote Originally Posted by EddyCurrent View Post
silyavski, I knew you could not resist to comment on a frame design

I got the first part but I'm sorry I did not fully understand how to draw everything you said in the second part, but here is some of it

Click image for larger version.  Name: frame6-6.jpg  Views: 4350  Size: 104.5 KB  ID: 10484
It was irresistible

Sorry about my English.

I meant what you did to the sides to do it at the base square and remove the middle piece / the plane at the bottom, the bottom horizontal rectangular plane i am talking/

At the long side planes which you changed, remove the lower 2 diagonals and solder there what you call gussets instead /yellow/. And now that the 2 remaining diagonals are ok at their upper ends, make them longer below to go and touch to 20cm up, measured from the bottom of the legs. Dont move their upper ends

Make same at your short side vertical planes/ the face of the machine and the back/ and there you have it. Here you should shorten more the diagonals and make them touch 20cm from bottom or even higher.