Ready Steady Eddy

[Wobblycogs]

I like that top vent, do you have a source for them?

I'm hoping they come in 80mm square versions. I currently have regular fan filters at the top to stop crud getting in but I think the air flow restriction they cause will be too great so a vent like that would be perfect. The alternative is to fit a couple more fans at the top but that then risks creating a negative pressure in the case.

[EddyCurrent]

I like that top vent, do you have a source for them?

Home made from an old IKEA metal shelf, sometimes I don't mind a bit of sheet metal working, I was going to use the side cut from an old washing machine, another good source of sheet metal.
I drew it in Sketchup to get a template for cutting it out of a flat sheet.

[JAZZCNC]

Eddy noticed you have wire tags or numbers on your wires where did you get those.? . . . I've looked around but can't find any at sensible money.

[Lee Roberts]

I like that top vent, do you have a source for them?

I'm hoping they come in 80mm square versions. I currently have regular fan filters at the top to stop crud getting in but I think the air flow restriction they cause will be too great so a vent like that would be perfect. The alternative is to fit a couple more fans at the top but that then risks creating a negative pressure in the case.

Cogs, for evey exhust fan you have, you need twice the amount for intake fans, this creates the "flow" through the box. I like the look of Eddys vent on the top but would have preferred to see a 4 fan array there instead or as well.

.Me