Threaded View
-
15-09-2013 #3
Last Activity: 7 Hours Ago
That would apply if I was changing the frequency, however for this application the frequency would be fixed at 50Hz when powered, although it would need to ramp up/down when powered on/off, but that could be set to a minimal amount.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
NEW MEMBER: i didnt think i was stupid but i do now!
By stone in forum New Member IntroductionsReplies: 12Last Post: 17-03-2013, 08:49 PM -
Stupid question I know... but - What size is my Spindle Collet ?
By Fivetide in forum Milling Machines, Builds & ConversionsReplies: 17Last Post: 25-11-2012, 03:34 PM -
Chip load chart
By motoxy in forum Machine DiscussionReplies: 1Last Post: 17-09-2012, 10:05 PM -
How to pre load screws
By graham4877 in forum Lead Screws, Nuts & SupportsReplies: 6Last Post: 14-08-2012, 11:07 AM -
VFDs?
By graffian in forum Motor Drivers & ControllersReplies: 9Last Post: 30-06-2010, 04:42 AM
Bookmarks