Quite an Unusual one

[Boyan Silyavski]

First time i did it not entirely right. With time discovered new ways and next time i did it welded 6mm or 8mm bar stock, distance 40mm between. Have to check if it was 8mm as it may touch the Hiwin 20 block. Better read my second build log to see how i poured a couple of times epoxy on a 3m machine untill i figure the perfect way. iin short i discovered that the most important part is to make the damned dam longer like 15 cm at least than the actual machine to compensate for the shrink and that way only one bridge is enough, and the bridge must be then outside the machine. So when all dries and shrinks, the bridge will not eat from the actual ways but from the extra length. If you know what i mean