Thread: Quite an Unusual one
Threaded View
-
26-09-2013 #9
Yes was just to avoid swapping but if you have room for extra wide Y axis that would work OK
Yes easily. 30mm bearings are massive things and can handle large loads.
Will ballscrews with 2 nuts each stand up to the task and especially on Z, where additional vibrational creep has to be dealt with? Z with 2 ballscrews and 4 nuts should stand , yes? Ok, not forever, but at least for a time.
What size ballscrews on each axis? the normal speedy ones? 1605 and 1610 respectively?[/QUOTE]
Don't think 2 nuts would matter or help in this instance has reducing backlash isn't required.
Regards Z axis then Obviously two screws will take more punishment than one but single screw would just means changing sooner and less complicated.!
Yes standard screw pitch and either 16 or 20mm should be fine.
Thread Information
Users Browsing this Thread
There are currently 3 users browsing this thread. (0 members and 3 guests)
Bookmarks