What i meant was i can spot the 0.05-0,1 mm gap between a straight edge and something, say rail or other flat surface. Not that i can spot if the machine is straight or not over all its length or width. I spent a week just making sure the long rails are mounted straight and flat, not counting the epoxy.



Yeah, without DTI its difficult to say more.


What do you mean to tram the spindle? Its trammed already using 2m straight edge and squares. There will be no more tramming until the moment i cut some square aluminum shapes and first i make sure the gantry is squared by the limit switches and later do some stuff and see if there is something off judging by the final dimensions of the work.

Then the bed would be surfaced or head trammed first, but only if i am off by a great deal, depends on what results tell me. It is very easy in fact to tram it all as i always followed your advice of adjust ability making all through holes bigger.

Now about the DTI. I could clamp it now on one side rail and move the head assembly up down and see what DTI says but ... ok i went and clamped it. It says nothing, i mean i mounted all very well only using the squares and edge. Unbelievable but true.

I will power the whole thing then check and readjust if necessary, cause its very difficult to move all by hand. long distances i mean and i get bored.

At the end even if vertically is off with 0.1mm on 200mm travel/ which is not the case/, this is nothing. on 20mm aluminum sheet the inclination would be 200/20=10, so 0.01/10=0.01mm