. .

Thread: Tool Pre-setter

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 27-09-2013 #3
    Leadhead's Avatar
    Lives in Portsmouth, United Kingdom.
    Leadhead
    Last Activity: 02-09-2024 Has been a member for 9-10 years. Has a total post count of 329. Received thanks 13 times, giving thanks to others 30 times.
    Yes - I have a scheme to use a small linear bearing and a small piece of ground shaft to suit. Acting on an old Mercer clock. But as usual not getting "round tuit"
    So was looking for any expedient.
    I run on an ER32 collet set and have to change tools (and collets) at the tool call. So have to set height on each occasion, since there is no reliable backstop position for most of my tooling. - Unless anyone has a method to share??
    Last edited by Leadhead; 27-09-2013 at 10:19 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Z axis height setter
    By phill05 in forum General Discussion
    Replies: 7
    Last Post: 29-11-2016, 01:14 PM
  2. CNC programmer, setter, operator required
    By newtoid1986 in forum Opportunities Available & Sought
    Replies: 0
    Last Post: 25-07-2013, 01:39 PM
  3. Mach 3 tool setter Big-tex version / script help please
    By dudz in forum Probing, Digitizing & Scaning
    Replies: 0
    Last Post: 25-06-2013, 08:01 PM
  4. CNC Programmer/Setter - Mid Wales
    By CNC IT in forum Opportunities Available & Sought
    Replies: 0
    Last Post: 19-10-2011, 04:55 PM
  5. Permanent CNC Programmer/Setter/Operator, Kent
    By JJE in forum Opportunities Available & Sought
    Replies: 0
    Last Post: 17-06-2011, 11:56 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules