Thread: One limit switch per axis
-
29-09-2013 #11
If I was using servos and encoders I would be using the absolute type and as you say soft limits would be my choice with hard limits providing final limits. As I'm using stepper motors this is not an option so while I could fit encoders I've decided to just fit switches. As you say, once these switches have been activated there must be a way to recover and I admit I have not investigated this aspect yet but I'm sure there is a simple solution such as an override button as you mention. With regard to limit switches these are always in the normally closed mode and are opened upon activation, this means that if the wire is broken or the connection fails the system will stop.
-
29-09-2013 #12
Removed by me
Last edited by Ulsterman; 29-09-2013 at 11:39 PM.
-
29-09-2013 #13
Just ignore, I seem to have posted twice.
Last edited by EddyCurrent; 29-09-2013 at 10:52 PM.
-
29-09-2013 #14
All safety systems, and limit switches are just that, should ALWAYS fail safe. This means that a failure if the wiring or of a connector MUST result in a fail condition. Being stuck in e-stop nay be inconvenient but no system should ever be designed that cannot validate that it's safety mechanisms are working therefore continuity of limit switches and their wiring is a fundamental pre-run test. It's also why e-stop and limit switches should interlock directly on motor power and not rely on software intervention. You should ALWAYS require some manual action to over-ride e-stop or limit switches, usually by holding down a momentary contact switch while cycling power or performing a software reset action.
-
29-09-2013 #15
No that's unsafe and it's very common for a wire to break or come disconnected in which case the machine E-stops.
Doesn't matter if the switch is stuck after being tripped because E-stop is still affective it just means you have to find the faulty sticking switch which you would want to do anyway.
Regards the Limit over ride then I use Momentary button with Buzzer warning it's overridden.
-
29-09-2013 #16
Thanks jazz your right should be that way so always a break in power detected for these and Estops -sorry for the mix up
-
30-09-2013 #17
No problem understand and like said was being pedantic but it's small things like these that new folks pickup on and see from other post's that your knowledgeable so take that it's correct and use it.!!. . . I see it often with helping new users so it jumps out at me and wasn't trying to put you down just clear it up.
-
30-09-2013 #18
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Limit switch issues?!?
By jonbabbz in forum General ElectronicsReplies: 10Last Post: 06-02-2014, 07:37 PM -
Another Home - Limit switch question
By Cube3 in forum General ElectronicsReplies: 6Last Post: 26-12-2013, 07:51 PM -
FOR SALE: Z axis with Home/limit switch and Nema 23 3nm
By Shinobiwan in forum Items For SaleReplies: 6Last Post: 02-02-2013, 10:54 AM -
Limit switch Cable ...
By Wobblybootie in forum General ElectronicsReplies: 3Last Post: 17-01-2011, 04:37 PM -
Limit switch's - best configuration?
By HiltonSteve in forum General ElectronicsReplies: 16Last Post: 13-08-2009, 01:26 PM
Bookmarks