-
29-09-2013 #1
Hey, so I've been looking on my new favorite site, Aliexpress :D..
and have been looking at stepper motors,
from what I under stand all nema 23 motors have the same sort of face profile so the longer the motor, more juice it needs and more torque it has.
but how is it, that the nema23 stepper motors from CNC4U are 3.1nm and only 88mm long but on aliexpress a nema23 motor with a length of 115mm is only 2.5nm
my only guess would be that these readings are taken at different voltages? :S
if so should I buy on length or holding torque?
Thanks
115mm nema 23 motor
nema 23 3.1nm
-
Well a lot of people on here seem to favour the nema 23 3.1nm from CNC4U as they are good value and seem to have passed the test of time. ..Clive
-
29-09-2013 #3
Torque is related to current but holding torque is of little relevance for CNC use. More critical is winding inductance, the smaller the better and winding resistance, again the smaller the better. These determine the real torque available and how fast it drops off with speed. On that basis the smaller cnc4you motors are far far better. The ones on Aliexpress look like an older design and may represent over stock of something built for a specific customer.
-
30-09-2013 #4
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
What size stepper motor do I-need.
By irving2008 in forum Stepper & Servo MotorsReplies: 46Last Post: 15-06-2017, 09:18 AM -
Stepper Motor Driver - cheap similar to ArcEuro 4.2A Bi-Polar Stepper Motor Driver
By craynerd in forum Motor Drivers & ControllersReplies: 1Last Post: 16-03-2014, 07:29 PM -
Stepper motor wiring
By Buba b in forum Stepper & Servo MotorsReplies: 5Last Post: 28-03-2010, 06:16 PM -
Stepper motor help.
By Kammo1 in forum Stepper & Servo MotorsReplies: 4Last Post: 12-02-2010, 11:11 AM -
Stepper motor help
By Mucky Mike in forum Stepper & Servo MotorsReplies: 2Last Post: 04-04-2009, 04:25 AM
Bookmarks